Adding/Replacing Bluetooth Phones; Programming Table - Scytek electronic Precision Blue Product Manual

Adding/Replacing Bluetooth Phone (2 Phones maximum)
1- Set the BlueTooth enabled phone name to ScyTek.
2- Turn on the ignition key On, Off, and back On. 10 times.
3- The LED will illuminate.
4- Set the BlueTooth enabled phone to discoverable mode.
5- Turn Ignition Off.
6- The LED will start Flashing.
7- Once the Phone has been detected the LED will turn Off.
8- Change the BlueTooth enabled phone name to original name other than
ScyTek.

Programming Table

Branch Feature
1. Exit Delay (Seconds)
2. Ignition Controlled Lock
3. Ignition Controlled Unlock
4. Door Lock Pulse Length
5. Door Unlock Pulse
6. Horn/Sidelight Option
7. Extended Parking Lights
8. Horn Pulse Duration
Adding a second Bluetooth cellphone
connect a second Precision Blue module to the first ( master) unit with a 3 pin Cnet
connector.
Set the second Precision Blue module to slave mode by Removing the master/slave jumper inside the module.
1- Set the BlueTooth enabled phone name to ScyTek.
2- Turn on the ignition key On, Off, and back On. 10 times.
3- The LED will illuminate.
4- Press and release the valet switch one time.
5- Set the BlueTooth enabled phone to discoverable mode.
6- Turn Ignition off.
7- The LED will start Flashing.
8- Once the Phone has been detected the LED will turn Off.
9- Change the BlueTooth enabled phone name to original name other than
ScyTek.
Page 2 - Precision Blue
Ignition OFF/ON
1 Time (default)
10
On
On
1 Second
Single
Horn
On
Normal
Ignition OFF/ON
2 Times
15
Off
Off
3 Seconds
Double
Sidelight
Off
Extended
Ignition OFF/ON
3 Times
20
0.1 Second