Scytek electronic ASTRA 100RS Product Manual

Automatic/manual transmission remote start system

Advertisement

ASTRA 100RS
AUTOMATIC/MANUAL TRANSMISSION
REMOTE START SYSTEM
PRODUCT MANUAL

Advertisement

Table of Contents
loading

Summary of Contents for Scytek electronic ASTRA 100RS

  • Page 1 ASTRA 100RS AUTOMATIC/MANUAL TRANSMISSION REMOTE START SYSTEM PRODUCT MANUAL...
  • Page 2 Limited Lifetime Warranty This vehicle security system is warranted to the original purchaser, to be free from defects in material and workmanship. The manufacturer will repair or replace at its option, and free of charge for the first twelve (12) months, any part that proves defective in material or workmanship under normal installation, use, and service, provided the product is returned to the manufacturer freight prepaid.
  • Page 3: Table Of Contents

    About Your System ........... .Page 1 Remote Transmitters .
  • Page 4 Page 4 - Astra 100RS...
  • Page 5: About Your System

    DO NOT install Astra 100RS remote starting system on MANUAL TRANSMISSION vehicles without verifying that the system is in Manual Transmission Mode. If accidentally left in gear the vehicle could become a self-propelled threat to life and property.
  • Page 6: Remote Transmitters

    · The parking lights will flash twice to indicate it has learned the code. 5. Repeat steps 3 and 4 for each transmitter (up to 4). 6. Turn off the ignition key. · The parking lights will flash 3 times. Page 2 - Astra 100RS Remote Transmitters...
  • Page 7: Battery Replacement

    In order to change the battery, first remove the screw from the back of the transmitter and separate the top and bottom halves of the case. While replacing the battery make sure that the positive and negative terminals are positioned correctly, then carefully reassemble the transmitter case. Astra 100RS - Page 3...
  • Page 8: System Operation

    3 times the parking lights will flash 4 times and the doors will lock (if installed). Turn on the ignition and press the brake pedal to disengage the remote start feature and drive the vehicle. Page 4 - Astra 100RS System Operation...
  • Page 9: Shut Down

    3. You may now exit the vehicle and lock the doors. To resume control of the vehicle: 1. Unlock the doors 2. Turn on the ignition. 3. Press the Brake Pedal to disengage the remote start. Astra 100RS - Page 5...
  • Page 10: Extended Features

    · The Turbo Timer countdown will automatically stop and the engine will shutdown. WARNING: the Turbo Timer feature is not intended for use inside garages or other non-ventilated areas. Make sure to deactivate the Turbo Timer feature when parking in such areas. Page 6 - Astra 100RS Extended Features...
  • Page 11: System Installation

    After installation is complete and performance verified, the control unit can be easily mounted using wire ties through the mounting tabs on the bottom of the unit. System Installation 2-Pin Override Switch harness • Astra 100RS - Page 7...
  • Page 12: System Wiring

    Pin 14 GREEN/WHITE WIRE: Brake Input (+). Connect to the wire that shows +12V when pressing the brake. The Green/white wire is a safety shutdown wire that must be connected. Pin 15 WHITE WIRE: Parking Light Output (+/-) relay. Connect the White wire to the circuit that shows Page 8 - Astra 100RS System Wiring...
  • Page 13: Plug-In Connectors

    5 Times - Unit is in Valet (service) mode, and start is disabled. 6 Times - Handbrake Off (Manual Transmission Mode Only). 7 Times - Start sequence not initiated (Manual Transmission Mode Only). Starter Diagnostics Astra 100RS - Page 9...
  • Page 14: Jumper Settings

    Parking Light Output. Selects the polarity (+/-) for the output of the on-board Parking Light relay. Left Pin + Center Pin = positive Right Pin + Center Pin = negative Page 10 - Astra 100RS Jumper Settings default setting shown...
  • Page 15: System Programming

    7. Start in Valet Mode. Selects if vehicle should start when in Valet. 8. Reserved. 9. Reserved. 10. Engine Run Time. Selects between 15 or 25 minutes for the remote start run cycle. 11. Reserved. System Programming Astra 100RS - Page 11...
  • Page 16 17. Rearm/Horn Output Mode. Pin 9 VIOLET/WHITE wire is selected to act as a Factory Rearm output or Horn Output Horn output wiith chirps enabled or Horn output wiith chirps Disabled 18. Smart Start Run Monitor. When enabled smart mode monitors engine run condition during remote start. Page 12 - Astra 100RS...
  • Page 17: Branch Table

    All Disabled Turbo Mode Enabled N.A. N.A. Rearm Horn Enabled Disabled Relay Diagrams Code 3 N.A. N.A. N.A. N.A. N.A. N.A. N.A. N.A. Super Extended Diesel Engine Starter 2 Output Alternate Start Enabled Horn Chirp disabled Astra 100RS - Page 13...
  • Page 18 Relay Diagrams Cont. Negative Glow Plug Page 14 - Astra 100RS...
  • Page 19: Wiring Diagrams

    Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation Orange Yellow Violet Brown Wiring Diagram Astra 100RS - Page 15...
  • Page 20 Red - +12V Input (+) ScyTek Electronics 11627 Cantara Street North Hollywood, CA 91605 www.scytek.net Orange - Accessory Output Yellow - Ignition 1 Output Violet - Starter Output Brown - Ignition 2 Output Red - +12V to Relays Astra 100RS r1 8/10/06...

Table of Contents