Table of Contents
Advertisement
1. Thoroughly read and become familiar with the installation instructions before beginning the
installation.
2. Review system contents:
Main Unit
1 Precision Blue Main Module
1 Main Harnesses ( 7 wires)
6-Pin Antenna Receiver harness
•
LED harness
•
Valet Switch harness
•
Receiver Harness
•
3. Verify with the owner, the mounting locations for all visible components, including the LED
and Override switch.
4. Verify with the owner, the optional features of the Precision Blue and the functions that must
be programmed during installation.
5. Inspect and perform a function test of all vehicle systems before and after the installation.
6. Always use a Volt / Ohm meter for testing vehicle circuits. Never use a test light.
7. Always look before drilling any holes or mounting self-tapping screws. Be sure fuel lines and
exterior wiring looms are clear as they are often close to the chassis and difficult to see.
8. Protect all wires running from the engine compartment to the interior of the vehicle by
covering with electrical tape and split loom tubing. Be sure to use a grommet when routing
wires through the firewall.
9. Properly fuse any additional accessories such as window modules, door lock actuator, etc.,
making sure to power them separate from the alarm module. This will ensure the
functionality of the security system in the event of an accessory failure.
Mounting Bluetooth Antenna
Mount the antenna on the top center of the windshield for maximum range.
Page 4 - Precision Blue
System Installation
Advertisement
Table of Contents
