Using The Skew Correction Mode - Ricoh Caplio 500G wide User Manual

Using the Skew Correction Mode

1
Turn the mode dial to 5.
2
Press the SCENE button.
• The Scene Mode selection screen appears.
3
Press the !" buttons to select [SKEW COR
MODE].
4
Press the C/D button.
5
Press the shutter release button to shoot the
subject.
• Immediately after shooting, the area recognized as the
correction range is displayed with an orange frame. Up to five
areas can be recognized.
• To select another correction area, move the orange frame to the
target area by pressing the $ button.
6
Press the C/D button.
• The corrected image is recorded. The image before correction is
also recorded.
• To cancel skew correction, press the ! button. Even if you
cancel skew correction, the image before skew correction
remains recorded.
• If the target area cannot be detected, an error message appears.
Note ---------------------------------------------------------------------------------------------------
When [SKEW COR MODE] is selected, note the following:
• To shoot the subject as large as possible, position it so that the entire portion of the
subject is visible on the LCD monitor.
• The camera may fail to recognize the subject in the following cases:
• When the image is out of focus
• When four edges of the subject are not clearly visible
• When it is hard to distinguish between the subject and background
• When the background is complicated
• Two images, one before correction and the other after correction, are recorded. If the
number of remaining shots is less than two, you cannot shoot the subject.
• If the camera is unable to detect a correction area, the image before correction
remains recorded.
42