Brother MFC-J4710DW Advanced User's Manual page 77

PhotoCapture Center™: Printing photos from a memory card or USB Flash memory drive
b
Put the memory card or USB Flash
memory drive in the correct slot.
c
Press Scan to Media.
d
Load your document.
e
Press Options.
f
Swipe up or down, or press a or b to
display Auto Crop.
g
Press Auto Crop.
h
Press On.
i
Press OK.
j
If you do not want to change additional
settings, press Start to start scanning.
k
The number of the scanned documents
appears on the Touchscreen.
Press OK to confirm.
l
Press d or c to preview the data for each
document.
m
Press Save All to save the data.
NOTE
• Auto Crop is available for paper with
right angles of 90 degrees at all four
corners. If one of the angles is not square,
Auto Crop cannot detect the document.
• If your document is too long or wide, this
setting does not work properly. The
document has to meet the following
specification: up to 7.7  10.6 in.
(195  270 mm).
If the ratio between the height and width of
the document is more than 1 to 8, this
setting does not work correctly.
• You must place the documents away from
the edges of the scanner glass as shown
in the illustration.
• You must place the documents at least
0.4 in. (10 mm) apart from each other.
• Auto Crop adjusts the skew of the
document on the scanner glass, but if your
document is skewed more than
10 degrees, this setting will not work.
• The ADF must be empty to use the
Auto Crop.
• The Auto Crop feature is available for up
to a maximum of 16 documents
depending on the size of your documents.
• (MFC-J4710DW)
2-sided Scan and Skip Blank Page
are not available with Auto Crop.
IMPORTANT
DO NOT take out the memory card or
USB Flash memory drive while the
machine is reading or writing to the
memory card or USB Flash memory drive
to avoid damaging the card, USB Flash
memory drive, or the data stored on them.
8
71