Ending - Epson EMP 5600 Owner's Manual

I I I I Ending
End through the following procedure.
1
Turn off the connected equipment.
2
Press the [Power] button.
A message to confirm that the power needs to be switched off will be displayed.
Power
Power
3
Press the [Power] button once more.
The lamp will be extinguished, the Operation Indicator will blink in orange, and the cool-
down process will commence.
Power
Power
The Operation Indicator will change from blinking to being illuminated in orange once the
cool-down process has been completed. The amount of time required for the cool down is
approximately 60 seconds (may be longer depending on the ambient temperature).
Point
· Press a different button if the power is not to be switched off. The message will be erased
after seven seconds if no buttons are pressed (the power will remain on).
· It is also possible to end projection by pressing the [Power] button as explained in proce-
dure #2 for more than one second (will assume the same status as if ending with proce-
dure #3).
· Button operations are not possible when the Operation Indicator is blinking in orange. In
this event, please wait until full illumination has been attained.
Computer Video Menu Sync Esc
A/V mute
Tracking Tracking
Resize Keystone
Shift Volume Sync
Power OFF?
Please press
to power off.
Computer Video Menu Sync Esc
A/V mute
Tracking
Resize Keystone
Volume
Shift Sync
Help
Power
Key again
Power
Help
Power
Tracking
Power
Freeze
A/V Mute
R/C ON
E-Zoom
OFF
3
Enter
Esc
Power
Freeze
A/V Mute
R/C ON
E-Zoom
OFF
3
Enter
Esc

Ending - 45