Replacement Method - Epson EMP 5600 Owner's Manual

Replacement method

1
Switch off the power supply, allow the projector to cool down, and then disconnect the
Power Cord.
The amount of time required for the projector to cool down will depend on the surround-
ing temperature.
2
Remove the lamp cover only after the lamp has cooled sufficiently.
· It will take at least 60 minutes for the lamp to cool sufficiently.
· Loosen the screw fixing the lamp cover in place with the screwdriver provided with the
replacement lamp. Pull the right-hand side of the lamp cover slightly forwards to release
the hook, slide it to the left and then remove the entire cover.
3
Withdraw the lamp.
Loosen the two screws holding the lamp in place, and then pull the lamp out towards you.
4
Attach a new lamp.
Align the direction, push the lamp in as far as it will go, and then secure it in place with
the two screws.
88 - Replacing the Lamp
Avoid an open/close
angle exceeding 15
degrees when pulling
the cover forward. The
use of excessive force
may result in the clip on
the hook bending.