Temperature Indicator - Epson EMP 5600 Owner's Manual

Temperature Indicator

Indicator Status
Illuminated in Red
Blinking in Red
Blinks in orange
Extinguished
Point
· Refer to the section on [When the Indicators Provide No Help] on the following page if the
Indicators appear normal but the projected image is defective.
· Contact your dealer if an Indicator status not covered by the above table is apparent.
76 - Troubleshooting
Cause
Excesive internal
temperature
(overheating)
Internal error
High-temperature
cooling in progress
Recovery and Status
· Use the projector within the permissible
temperature range of between 5 degrees
Celsius and 40 degrees Celsius.
· Install the projector in a well-ventilated place
and ensure that the ventilation inlet and
outlet are not blocked.
· Clean the Air Filter.
Cease operations, remove the Power Plug
from the socket and contact your dealer or
nearest address provided at page 97 and
request repairs.
· (This is not an error, but the projector will
automatically cease operating if the
temperature increases any further.)
· Use the projector within the permissible
temperature range of between 5 degrees
Celsius and 40 degrees Celsius.
· Install the projector in a well-ventilated place
and ensure that the ventilation inlet and
outlet are not blocked.
· Clean the Air Filter.
(Not an error)
The power has not been switched on or nor-
mal projection is in progress.
Reference
Page
23
85
23
85