To Install Batteries; Turning The Laser Measuring Tool On And Off - Craftsman 320.48298 Product Manual

TO INSTALL BATTERIES
(See Fig. 3)
This laser measuring tool
uses two ",CA" batteries (sold
separately).
't.
Open the battery cover as
indicated bY the arrow on
the battery cover.
2_
Insert two new "AA "alka-
line batteries according to
the polarity indicators in
the battery compartment.
Be sure the polarity (+/-)
is correct!
Fig. 3
3. Close the cover and lock it securely in place.
NOTE:
o Replace the batteries when the battery indicator shows empty.
= Remove the batteries from the measuring tool when not using it for
extended periods.
o The 2 AA batteries should match each other in brand and type.
,, Do not mix old and new batteries.
o Remove dead batteries immediately, and dispose of them according to your
local ordinance. Never dispose of batteries in fire.
TURNING THE LASER MEASURING TOOL ON AND OFF
I.
2_
3o
4_
Press the ON/OFF key to turn on the tool. The CRAFTSMAN logo will show
on the screen for one second, then it will automatically change to the single-
distance measurement mode, indicating that the tool it is ready to take
measurements.
Press the ON/OFF key for about 2 seconds to turn off the tool.
When the measuring tool is inactive for 5 minutes, it will automatically turn
off to save battery power,
When the tool is powered off, whether manually or automatically, the mea-
suring data saved in the memory will be cleared.
USING THE LASER MEASURING TOOL
Hold the tool at the point from which you want to measure. The default refer-
ence setting is from the rear of the tool. By pressing the i_ key, the setting can be
changed, so that the next measurement will be taken from the "front" of the tool.
48298 ManuaLRevised_07-0225 Page 8