Replacing Batteries; Replacing Fuses - Craftsman 82140 Owner's Manual

REPLACING THE BATTERIES
l WARNING: To avoid electric shock, disconnect the test leads from any
source of voltage before removing the battery door.
I
1. When the batteries become exhausted or drop below the operating
voltage, "BAT" will appear in the right-hand side of the LCD display.
The batteries should be replaced.
2. Follow instructions for installing batteries. See the Battery Installation
section of this manual.
3. Dispose of the old batteries properly.
I WARNING: To avoid electric shock, do not operate your meter until the 1
battery door is in place and fastened securely.
REPLACING THE FUSES
l WARNING: To avoid electric shock, disconnect the test leads from any source of voltage before removing the fuse door.
1.
2.
3.
4.
5.
6.
1
Disconnect the test leads from the meter and any item under test.
Remove the protective rubber holster.
Open the fuse door by loosening the screw on the door using a Phillips
head screwdriver.
Remove the old fuse from its holder by gently pulling it out.
Install the new fuse into the holder.
Always use a fuse of the proper size and value (0.2A/250V fast blow
for the 200mA range, 10A/250V fast blow for the 10A range).
Put the fuse door back in place. Insert the screw and tighten it securely.
WARNING: To avoid electric shock, do not operate your meter until the | fuse door is in place and fastened securely.
I
UL LISTED
The UL mark does not indicate that this product has been evaluated for the
accuracy of its readings.
16