Table of Contents
Advertisement
UNPACKING
Thisproductrequires a ssembly.
[] Carefully l ift sawfromthecartonbythecarrying handle
andthesawbase, a ndplaceit ona tevel w orksurface.
NOTE: Thissawis heavy. T oavoidbackinjury, l iftwith
yourlegs,notyourback,andget helpwhenneeded.
[] Thissawhasbeenshipped withthesawarmsecured
inthedownposition. Torelease thesawarm,push
downonthetop of thesawarm,cutthetie+wrap, and
pulloutonthelockpin.
[] Liftthesawarmbythehandle. H andpressure s hould
remain onthesawarmto prevent s udden riseupon
release ofthetie wrap.
[] hspectthetoolcarefully t o makesurenobreakage o r
damage occurred duringshipping.
[] Donotdiscard thepacking material untilyouhave
carefully inspected andsatisfactorily o perated thetool.
[] Thesawisfactorysetforaccurate cutting. A fter
assembling i t, checkforaccuracy. H f shipping has
influenced t hesettings, r efertospecificprocedures
explained inthis manual.
[] Hf a nypartsaredamaged or missing, please call
1+800+932+3188
forassistance.
_
WARNING:If anypartsaremissing, do notoperate
thistooluntilthe missing partsarereplaced. Failure
to do socouldresult i n possible serious personal
injury.
WARNING:Donotattempt t o modifythistool
or createaccessories not recommended for use
withthistool.Anysuchalteration or modification i s
misuse andcouldresult i na hazardous c ondition
leading to possible serious personal injury.
WARNING:Donotconnect t o power supplyuntil
assembly is complete. F ailure t o complycouldresult
inaccidental starting andpossible serious personal
injury.
MOUNTINGHOLES
See Figure 8.
_
WARNING:
Always make sure the compound miter
saw is securely mounted to a workbench or an ap-
proved workstand.
Failure to heed this warning can
result in serious personal injury.
The compound
miter saw should be permanently mount-
ed to a firm supporting surface such as a workbench.
Four bolt holes have been provided in the saw base for
this purpose. Each of the four mounting holes should be
bolted securely using 3/8 in. machine bolts, lock washers,
and hex nuts (not included). Bolts should be of sufficient
length to accommodate
the saw base, lock washers, hex
nuts, and the thickness of the workbench.
Tighten all four bolts securely.
The hole pattern for mounting to a workbench
is shown in
figure 8. Carefully check the workbench
after mounting to
make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the workbench
to the floor before operating.
TRACEHOLES
ATTHESELOCATIONS FOR
HOLEPATTERN
TRACEHOLES
ATTHESELOCATIONS FOR
HOLEPATTERN
BASE
[VIOUNTING SURFACE
Fig. 8
15
Advertisement
Table of Contents
