Table of Contents
Advertisement
CHANGINGTHEBATTERIES
See Figures 47 - 48.
[] Unplug the saw.
Remove the laser guide from the saw. Lay laser guide on
a flat surface with the two phillips screws facing upward.
Remove the screws and separate the laser guide cover
from the laser guide support.
Remove the three button cell batteries using a non-con-
ductive device such as a toothpick.
NOTE: Replace the batteries with silver oxide batteries
that have a rating of 1.5 volt and 180 mah (milliampere
hour) minimum (Number 357 silver oxide only).
When replacing the batteries, the laser guide should be
thoroughly cleaned. Use a soft paintbrush or similar de=
vice, to remove all sawdust and debris.
Do not attempt
to activate the laser.
The laser is activated by means of a centrifugal switch
only while the saw motor is running and the laser guide is
mounted on the saw.
After cleaning laser guide and replacing batteries, secure
laser guide cover to laser guide support using the two
phillips head screws. For proper assembly, be sure to
align the key on the laser guide cover with the key slot in
the laser guide support. Tighten screws securely.
NOTE: Aperture in laser guide cover must be aligned with
aperture in laser guide support.
_[_
CAU'TION:
Use of controls or adjustments
or per-
formance of procedures other than those specified
herein may result in hazardous radiation exposure.
LASER GUIDE
SUPPORT
LASER GUIDE
SUPPORT
(UPSIDEDOWN VIEW)
LASERGUIDE
i
COVER
!
1
|
1
l
APERTURE
_
PLASTIC
BATTERIES
NEGATIVE (-)
KEY
SLOT
APERTURE
LASER GUIDE
Fig. 47
_
DANGER:
Laser radiation when open and inter-
lock defeated. AVOID DIRECT EYE EXPOSURE.
34
Fig. 48
Advertisement
Table of Contents
