Selecting When The Image Displays - Epson PowerLite 720c User Manual

User's Logo
Do you use this image?
YES NO
: Return : Select : Execute
note
You can also set up your
image as a startup screen.
Use the Advanced menu to
enable the startup screen; see
page 46.
Fine-tuning the Projector
44
6. When you see the message "Do you use this image?" select
and press . If you want to change the area selected, select
Enter
, press and repeat steps 4 through 6.
NO Enter
7. Use the directional buttons on the remote control to select a zoom
rate (display size), and then press
8. When you see the message "Do you save the user logo?," select
and press
YES Enter
not use the projector or other sources (computer, video, speaker,
etc.) while the logo is being saved.
9. When you see the message "Saving the user's logo is completed,"
press or
Esc Menu

Selecting When the Image Displays

After your image is saved, you can set it up as the no-signal message
and/or the screen that's displayed when you press the
button.
1. Press the button to display the main menu (if not already
Menu
displayed).
2. Use the directional buttons to highlight
3. Press to select the Setting menu.
Enter
4. Use the directional buttons to highlight
5. Use the directional buttons to select
button. This sets your image as the screen displayed when the
projector is not receiving a signal.
6. If you want to set up your image as the A/V Mute display, use the
directional buttons to move down to
7. Use the directional buttons to select
button. This sets your image as the screen displayed when you
press the
A/V Mute
8. When you're finished, press
To test your setting, press the
Press it again to turn off the image.
.
Enter
. Saving the logo may take a few minutes. Do
.
Setting
No-Signal Msg
Logo;
A/V Mute
Logo;
button.
or
Esc Menu
button to display your image.
A/V Mute
YES
A/V Mute
.
.
then press the
Enter
.
then press the
Enter
.