RULES FOR SAFE OPEF AT ON
Do not attempt
to operate this tool until you have read
in this manual
involving fire, e_ectric
shock, or serious
injury. Save owner's manual
and review frequently
instructing others who may use this tool
READ ALL INSTRUCTIONS
limitations as well as the specific potential hazards
related to this toot
body contact with grounded surfaces.
For example: Pipes, radiators, ranges, refrigerator
KEEP WORK AREA CLEAN.Cluttered
benches invite accidents
4. AVOID DANGEROUS
power toot in damp or wet locations or expose to
rain Keep work area wet[ lit
5. KEEP CHILDREN
visitors shoutd wear safety glasses and be kept a
safe distance from work area Do not tat visitors
contact tool or extension cord
When not in use tools
should be stored in a dry and high or locked-up
place - out of the _each of children
7. DON'T FORCE TOOL. tt will do the job better and
safer at the rate for which it was designed.
8. USE RIGHT TOOL.
Don't force small tool or
do the job of a heavy duty tool Don't
use tool for purpose not intended - for example - A
circular saw should never be used for cutting tree
limbs or logs.
WEAR PROPER APPAREL.
Do not wear loose
or jewelry that can get caught in tool's
moving parts and cause personal injury. Rubber
gloves and non-skid footwear are recommended
covering to contain long hair and keep it from being
drawn into nearby air vents
WEAR SAFETY GLASSES.
eyeglasses have only impact-resistant
are NOT safety glasses
PROTECT YOUR LUNGS. Wear a face mask or
dust mask if operation
protection during extended periods of operation
Use cramps or a vise io h01d
work It's safer than using your hand and it frees
both hands to operate tool
Keep proper footing and
baiance at all times
Do not use on a ladder or
MAINTAIN TOOLS WITH CARE.Keep tools sharp
at all times,
and changing accessories
16. REMOVE ADJUSTING
Form habit of checking
to see that keys and
adjusting wrenches are removed from tool before
turning it on.
NEVER USEIN AN EXPLOSIVE ATMOSPHERE.
Normal sparking of the motor could ignite flammable
Liquids,gases, or fumes
FROM OIL AND GREASE.
Always use a clean
cloth when cleaning
products or any strong
solvents to ctean your tool.
19. STAY ALERT. Watch what you are doing and use
common sense Do not operate toot when you are
Do not rush.
PARTS. Before further use of
the tool, a guard or other part that is damaged
should be carefully checked to deter mine that it _,_11
operate properly and perform its intended fun_
Check for alignment
of moving parts, bindir_
moving parts, breakage
of parts, mounting,
any other conditions that may affect its operation.
A guard or other part that is damaged
repaired or replaced
by an authorized
service center unless indicated elsewhere
Look for this symbol to point out important