Craftsman 315.111690 Owner's Manual page 3

Cordless screwdriver two speed / reversibble
Hide thumbs Also See for 315.111690:
Table of Contents

Advertisement

RULES
FOR SAFE
OPERATION
(Continued)
21
DO NOT USE TOOL tF SWITCH
DOES NOT
TURN IT ON AND OFF, Have defective switches
replaced by an authorized
service center
22
DRUGS,
ALCOHOL,
MEDICATION.
Do not
operate tool while under the influence of drugs,
alcohol, or any medication
23
DRIVING SCREWS INTO ELECTRICAL
WIRING
IN WALLS, CEILINGS, OR OTHER AREAS CAN
CAUSE THE SCREWDRIVER
BIT OR COLLET
TO BECOME ELECTRICALLY
LIVE.Do nottouch
metal parts when driving screws into a wait; grasp
only the insulated
handle(s)
or plastic housing
when using this tool Make sure hidden electrical
wiring, water pipes, and mechanical
hazards are
not in the path of the bit when driving screws into a
wall
INSPECT FOR and remove all nails from lumber
before driving screws
RULES
FOR
24
IMPORTANT
SAFETY
BATTERY
TOOI.S
contact with your skin, wash immediately
with
soap and water, then neutralize with lemon juice
or vinegar
tf liquid gets in your eyes, flush them
with clean water for at least 10 minutes, then seek
immediate medical attention
31
If carrying your battery tool at your side, make sure
it is not running and your finger is not on lhe swilch
Avoid accidental starting
32
SECURE WORK before applying power NEVER
hold workpiece in your hand or across your legs
33
WHEN
SERVICING
USE ONLY
IDENTICAL
CRAFTSMAN
REPLACEMENT
PARTS.
IMPORTANT
SAFETY
INSTRUCTIONS
FOR CHARGER
25
Battery tools do not have to be plugged
into an
electrical
outlet; therefore,
they are always
in
operating condition
Be aware of possible hazards
when not using your battery tool or when changing
accessories
26
USE ONLY THE CHARGER
PROVIDED
WITH
YOUR BATTERY
TOOL.
Do not substitute
any
other charger Use of another ct_arger could cause
batteries to explode causing possible serious injury
27
DO NOT PLACE BATTERY
TOOLS OR THEIR
BATTERIES
NEAR FIRE OR HEAT.
They may
explode
28
DO NOT CHARGE BATTERY TOOL IN A DAMP
OR WET LOCATION°
29
Your battery tool should be charged in a location
where the temperature
is mo_e than 50°F but less
than IO0°F
Jnder extreme usage or temperature
conditions,
batteq, o leakage may occur
If liquid comes in
34
SAVE THESE INSTRUCTIONS,
This manual
contains
important
safety
and
operating
instructions
for battery
charger
part number
999555-001
35
Before using battery charger, read atlinstructions
and cautionary markings in this manual, on battery
charger, and product using battery charger
36
, WARNING:
To reduce risk of injury,
charge
only nickel-
cadmium
type rechargeable
batteries
Other
types of batteries may burst causing
persona]
injury and damage
37
DO not expo"se charge'r to ;ain or snow
38
Use of an attachment
not recommended
or sold
by the battery charger manufacturer
may resutt in
a risk of fire, electric shock, or injury to persons
39
To reduce risk of damage to charger body and
cord, pull by charger body rather than cord when
disconnecting
charger
40
Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise subjected
to damage or stress
WARNING:
The operation
of any power
tool can result
in foreign
objects
being
thrown
into your
eyes,
which can result
in severe eye damage.
Before
beginning
power
too] operation,
always
wear
safety
goggles
or safety
glasses
with
side shields
and a full face shield
when
needed..
We
recommend
Wide Vision
Safety Mask for use over eyeglasses
or standard
safety
glasses
with
side shields,
available
at Sears Retail
Stores.
Page 3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents