How To Use The Throttle Control - Craftsman 536.772340 Operator's Manual

OPERATION
HOW TO STOP THE EDGER
Move the clutch lever back to the DIS-
ENGAGED position. Then, move the
throttle control to SLOW, then to STOP
(if equipped) See Figure 7.
_ WARNING: Never leave the
EDGER unattended while the
engine is running. Always dis-
engage the cutting blade and stop the
engine.
HOW TO USE
THE THROTTLE CONTROL
1. During normal use, run the engine at full
speed.
2. Move the throttle control up to increase
engine speed, or down to decrease en-
gine speed (see Figure 8).
Clutch Lever
Figure 7
I Throttle
ltl.o.o.o N i1 1
Figure 8
HOW TO USE
THE CLUTCH LEVER
1. Start the engine.
2. To engage the cutting blade, move the
clutch lever forward (see Figure 9).
3. Select the edging depth you need. There
are five selections down to approximate-
ly 2-3/4 inches deep.
NOTE: For deep edging, first cut at shallow
depths. Then, cut at greater depths until
the desired depth is obtained.
Clutch Lever
Figure 9
F-021102L 11