Service And Adjustment; How To Remove The Belt - Craftsman 536.772340 Operator's Manual

SERVICE AND ADJUSTMENT
HOW TO REMOVE THE BELT
The belt made of a special compound. If the 4. Loosen, do not remove, the screw that
belt becomes worn or breaks, replace the holds the belt guide. Then, move the
belt with an original equipment belt. belt guide away from the belt.
2.
Disconnect the spark plug wire from the
spark plug.
Pull the clutch lever back to release the
tension from the belt.
Remove the two screws and spacers
from the top of the engine pulley cover.
Remove the engine pulley cover (see
Figure 17).
5.
6.
Remove the two screws from the belt
guard (see Figure 18).
Remove the old belt from the engine
and quill assembly pulleys. Replace with
an original equipment belt.
7. To install a new belt, reverse the above
steps.
Screws
Screw
Engine
Figure 17
Belt Guard
_ Screw
Figure 18
F-021102L 19