Maintenance - Craftsman 351.22632 Owner's Manual

USING THE MITER GUAGE
The miter gauge is used only on the disc table. Use
the miter gauge for securing work and holding the pro*
per angle, while disc sanding
Adjust the angle by repositioning the miter gauge scale
(Key No 29) and locking it into place with thumbscrew
and flatwasher (Key Nos 31 & 30).
Check the accuracy of the miterguage scale,
Use a combination square to adjust the miter gauge
square to the face of the disc.
Indicator (Key No 32) should be at zero, Loosen screw
(Key No24) and reposition indicator if necessary
DUST COLLECTION:
The wheel cover has a I 1/4" diametel: exaust port in it
The exhaust port will accept a standard 1 1/4" Dust
collection hose.
Use the exhaust port to connect the belt and disc
sander to a shop vac or dust collector,
RECOMMENDED ACCESSORIES
ABRASIVE BELTS 1" x 42"
FINE ..................................... _ 26056
MEDIUM ............................. 9 26055
COARSE ................................. 9 26054
ABRASIVE DISCS 8" , ................... 922745
ALUMINUM DISC 8 ........................ 925135
STEEL STAND ..................... 922244
POWER TOOL KNOW HOW "HANDBOOKS"
TABLE SAW ............................... _ 2918
RADIAL SAW .......................... 9 2917
The above recommended accessories are current
and were available at the time this manual was
printed
MAINTENANCE
WARNING:
MAKE CERTAIN THAT THE UNITIS
DISCONNECTED FROM THE POWER SOURCE
BEFORE ATTEMPTING TO SERVICE OR REMOVE
ANY COMPONENT.
CLEANING
Keep machine and workshop clean. Do not allow
sawdust to accumulate on the belt and disc sander_
Keep the wheels clean, Dirt on wheels will cause poor
tracking and belt slippage.
LUBRICATION
The shielded ball bearings in this sander are per-
manently lubricated at the factory, they require no fur-
ther lubrication.
A small amount of machine oil can be applied to the
cam shaft (Key No 62) within the tracking bracket°
When operation seems stiff, a coat of automobile-type
wax applied to the belt table and disc table will make
it easier to feed the work while finishing.
Operate sander/grinder with dust collector to keep dust
from accumulating
IMPORTANT: AFTER SANDING WOOD OR NON-
METALLIC MATERIAL, ALWAYS CLEAN DUST COL-
LECTOR AND WHEEL GUARD OF SAWDUST
BEFORE GRINDING METAL THE SPARKS COULD
IGNITE THE DEBRIS AND CAUSE A FIRE
Do not apply wax to the belt platen, the belt could pick
up the wax and deposit it on the wheels, causing the
belt to slip.
KEEP SANDER IN REPAIR *."
If power cord is worn, cut, or damaged in any way, have
it replaced immediately,
Be certain motor is kept clean and is frequently
vacuumed or blown free of any dirL
Unpainted surfaces should be cleaned with penetrating
oil.
Replace V-belt and worn abrasives when needed.
Replace any damaged or missing parts, use the parts
list to order parts,
Use soap and water to clean painted parts, rubber parts
and plastic guards.