Epson 1EMP-S1 User Manual page 58

Appendices > Projector Care
C Loosen the fixing screws holding the lamp in place.
D Remove the old lamp.
E Install the new lamp.
Press the lamp until it clicks into place, then tighten the two fixing
screws.
F Replace the lamp cover.
First insert the tabs, and then press down on the opposite side until it
clicks into place.
• Install the lamp securely. If the lamp cover is removed, the
p
lamp turns off automatically as a safety precaution. The
lamp will not turn on if the lamp or the lamp cover is not
installed correctly.
• After replacing the lamp, be sure to reset the lamp
operating time.
• New air filters are included with replacement lamps. The
air filter should also be replaced when the lamp is replaced.
s "Lamp replacement period" P.56
• Dispose of used lamps properly in accordance with your
local regulations.
EMP-S1 User's Guide
57