Yournewtractorhas beenassembledat the factorywith exceptionof thoseparts left
unassembledfor shippingpurposes.Toensuresafe andproperoperationof your tractor
all partsand hardwareyou assemblemustbe tightenedsecurely.Usethe correcttools
as necessaryto insure propertightness.Reviewthe video cassettebeforeyou begin.
TOOLS
REQUIRED
FOR
• Position
steering
wheel so cross bars
ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need
are listed below.
(1) 9/16" wrench
(1) Phillips Screw-
driver
(1) Utility knife
(1) 3/4" socket with
drive ratchet
When right or left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating posi-
tion (seated behind the steering wheel).
(2) 1/2" wrench
(1) Pliers
(1) Tire pressure
gauge
TO REMOVE
TRACTOR
FROM
CARTON
UNPACK
CARTON
• Remove
all accessible
loose parts and
parts boxes from shipping
carton (See
page 6).
• Cut, from top to bottom,
along lines on
all four corners
of shipping
carton,
and
lay panels flat.
• Check for any additional
loose parts or
boxes and remove.
BEFORE ROLLING TRACTOR OFF
SKID
ATTACH
STEERING
WHEEL
ASSEMBLE
EXTENSION
SHAFT AND
BOOT
• Slide extension shaft onto lower steer-
ing shaft. Align mounting
holes in exten-
sion and lower shafts and install 5/16
hex bolt and Iocknut. Tighten
securely.
IMPORTANT:
Tighten
bolt and nut secure-
ly to 18-22 ft. Ibs. torque.
• Place tabs of steering
boot over tab
slots in dash and push down to secure.
INSTALL
STEERING
WHEEL
• Position
front wheels of the tractor
so
they are pointing
straight
forward.
• Slide steering
wheel
adapter
onto steer-
ing shaft extension.
are horizontal
(left to right) and slide
inside boot and onto adapter.
• Assemble
large flat washer, 3/8 lock
washer, 3/8 hex bolt and tighten securely.
• Snap steering
wheel insert into center
of steering
wheel.
• Remove
protective
materials
from trac-
tor hood and grill.
IMPORTANT:
Check for and remove any
staples
in skid that may puncture
tires
where tractor
is to roll off skid.
Insert
-_,F
3/8 Hex Bolt
_3/8
Lockwasher
"_-,---___ Large Flat
:;_ _-
_..Washer
rin g
Stee
Steering
Wheel
_
_Boot
Extension
''_"_ _Tab
Shaft
_
5/16 Locknut ----..__.
_"
Adapter
,_
5/16 Hex
Bolt
Lower Steering _
"-":'-- - -,,
TO ROLL TRACTOR
OFF SKID (See
Operation
section
for location
and
function
of controls)
• Press lift lever plunger and raise attach-
ment lift lever to its highest position.
• Release parking brake by depressing
clutch/brake
pedal.
• Place gearshift lever in neutral
(N) posi-
tion.
• Roll tractor
forward
off skid.
• Remove
banding
holding discharge
guard up against tractor.
8