Craftsman 143.213150 Owner's Manual page 18

This Drill Press has 12 speeds as listed below:
250 RPM 990 RPM
340 RPM 1550 RPM
390 RPM 1620 RPM
510 RPM 1900 RPM
600 RPM 2620 RPM
650 RPM 3100 RPM
See inside of belt guard for specific placement of belts
on pulleys.
SPINDLE SPEEDS iN R,P.M.
250
600
1620
340
65O
1900
390
990
2620
510
1550
, r,
3100
1. BELT GUARD ASSEMBLY . .. Covers pulleys
and belt during operation of drill press.
2. BELT TENSION LOCK HANDLES... Tightening
handles locks motor bracket support and BELT
TENSION HANDLE to maintain correct belt dis-
tance and tension.
3. BELT TENSION HANDLE... Turn handle counter
clockwise to apply tension to belt. turn handle
clockwise to release belt tension.
4. HEAD LOCKS... Lock the head to the column.
ALWAYS have them locked in place while operat-
ing the drill press,
5. FEED HANDLE . .. For moving the quill up or
down. One or two may be removed if necessary
6. COLUMN COLLAR... Holds the rack to the col-
umn. Rack remains movable in collar to permit
table support movements.
7. TABLE SUPPORT... Rides on column to support
arm and table.
8. TABLE CRANK . . . Turn clockwise to elevate
table, Support lockmust be released before operat-
ing crank.
9. RACK... Combines with gear mechanism to pro-
vide easy elevation of table by hand operated table
crank,
10. BASE,.. Supports Drill Press. For additional sta-
bility, holes are provided in base to bolt Drill Press
to floor. (See "Additional Safety Instructionsfor Drill
Presses.")
11. COLUMN SUPPORT... Supports column, guides
rack, and provides mounting holes for column to
base.
12. COLUMN... Connects head, table, and base on
a one-piece tube for easy alignment and move-
workpiece.
support
14. DEPTH SCALE... Shows depth of hole being
drilled.
15. DEPTH SCALE INDICATOR... Indicates drilling
depth selected on depth scale.
16. DEPTH SCALE LOCK... Locks the depth scale
to selected depth.
17. SPRING CAP ... Provides means to adjust quill
spnng tension.
18. CHUCK... Holds drill bit or other recommended
accessory to perform desired operations.
19. ARM... Extends beyond table support for mount-
ing and aligning the table.
20. TABLE BEVEL LOCK... Locks the table in any
position from 00-45 °.
21. TABLE LOCK,.. Table can be rotated in various
positions and locked,
22. BEVEL SCALE... Shows degree table is tilted
for bevel operations. Scale is mounted on side of
arm,
23. SUPPORT LOCK... Tightening locks table sup-
portto column. Always have it locked in place while
operating the Drill Press.
24. CHUCK KEY .. , It is a self-ejecting chuck key
which will "pop" out of the chuck when you let go
of it. This action is designed to help prevent throw-
ing of the chuck key from the chuck when power
is turned "ON", Do not use any other key as a
substitute, order a new one if damaged of lost.
25, BELTTENSION... Referto section"Assembly-In-
stalling and Tensioning Belt"
26. DRILLING SPEED... Can be changed by placing
the belt in any of the STEPS (grooves) in the pul-
leys. See Spindle Speed inside belt guard,
To determine the approximate drilling speed, refer
to the table inside the belt guard.
18