Cation And Function Of Controls - Craftsman 143.213150 Owner's Manual

location and function of controls
1. BELT TENSION HANDLE... Turn handle counter
clockwise to apply tension to bell turn handle
clockwise to release belt tension.
2. BELT TENSION LOCK HANDLES... Tightening
handles locks motor bracket support and BELT
TENSION HANDLE to maintain correct belt dis-
tance and tension.
3. HEAD LOCKS... Lock the head to the column,
ALWAYS have them locked in place while operat-
ing the drill press,
4. SUPPORT LOCK... Tightening locks table sup-
port to column. Always have it locked in place while
operating the Drill Press.
5. TABLE CRANK . . . Turn clockwise to elevate
table. Support lock must be released before operat-
ing crank.
6. TABLE BEVEL LOCK... Locks the table in any
position from 0'_-45 _
7. TABLE LOCK . . . Allows table to be rotated in
various positions and locked.
8. FEED HANDLE . . . For moving the quill up or
down. One or two may be removed if necessary
whenever the workpiece is of such unusual shape
that it interferes with the handles.
2
10
7
TABLE REMOVED
FOR CLARITY
9. CHUCK... Holds drill bit or other recommended
accessory to perform desired operations.
10. BEVEL SCALE... Shows degree table is tilted
for bevel operations, Scale is mounted on side of
arm.
11. SPRING CAP... Provides means to adjust quill
spring tension
12. DEPTH SCALE... Allows operator to adjust drill
press to drill to a desired depth.
13. DRILL "ON-OFF" SWITCH . . . Turns drill press
on and off .... also used to lock drill press in off
position.
14. LIGHT "ON-OFF" SWITCH,.. Turns the light on
and off.
15. CHUCK KEY... Used to tighten drill in the chuck
and also to loosen the chuck for drill removal.
16. DEPTH SCALE LOCK... Locks the depth scale
at selected position.
16
14
\
13
¢t)
0
(.3
"_€:
o o
0_-.
1--
I J-