Remove Skids From Base; Mounting Saw; Attach Elevation Crank; Elevate Arm To Its Maximum Height - Craftsman 113.19770 Owner's Manual

REMOVE SKIDS FROM BASE
MOUNTING SAW
1. From among the loose parts, find the following
hardware:
8 Hex Head Screws, 5/16-18 x 5/8
8 Lockwashers, 5/16 in. External Type
16 Washers, 11/32 ID
8 Hex Jam Nuts, 5/16-18
2. Place saw on legs so that holes in bottom of saw line up
with holes marked X in top of legs.
3. Install screws, washers and nuts as shown.
If you mount the saw on any other Craftsman base or flat
bench, make sure Elevation Crank has proper clearance to
rotate. The saw must be bolted down. Position saw to slope
slightly rearward, so when the carriage is installed it will not
roll forward due to gravity.
SAW' BASE _[
"tEX HEAD SCREW "_"_"_1 I
FLt', r WASHER--_, i
STIFFENER--'" l _ "t"]
FL_[ 'vVASHER _L , i
LQ<:KWASHER --"""_ _
LEG
1
R.q. STIFFCNER
!
o. Io
L.H. STIFFENER LEG
\ , l
o o_o ,_
)
×
r |
% o_oo
x x
j o oi
ATTACH ELEVATION CRANK.
Be sure setscrew s tightened on flat of shaft.
NG BLOCK
ELEVATION CRANK
(TURN CLOCKWISE)
ELEVATE ARM TO ITS MAXIMUM HEIGHT.
Remove shipping block and discard.
lo