On-Off Knob; Choice Of Blade And Speed - Craftsman Contactor 113.236400 Owner's Manual

ON-OFF KNOB
1. To turn machine 'ON', place fingers on Speed Con_
trol!On-Off Knob and pull out.
NOTE: A hesitation before blade movement, after
machine is turned 'ON', is a normal condition ol this
saw,
,= i , illll ii
2. Toturnmachine'OFF',pushin SpeedControl/On-Off
Knob. NEVER LEAVE THE MACHINE UNAT-
TENDED UNTIL IT HAS COME TO A COMPLETE
STOP.
The variable speed control may be adjusted to the
approximate speeds identified on the control panel.
Suggested speeds are identified under "Choice of
Blade and Speed". Turn the control knob clockwise
(/"'_ ) to increase strokes per minute and counter-
Clockwise (,_,"_) to reduce the strokes per minute.
H,=H==,H,,,,I =H
3. To lock knob in 'OFF' position, install a padlock
through the post above the knob as illustrated, and
lock the padlock. (Padlock is not supplied with the
saw.)
WARNING: For your own safety, always push
the knob 'OFF' when machine Is not in use.
Also, in the event of a power failure (all of your
lights go out), push knob 'OFF'. 'LOCKOUT'
your knobwitha padlock asshown. This will
prevent the machine from starting up again
when the power comes back on.
m,i ,i i[=[ = =1
15