Blade Tension Knob - Craftsman 119.224000 Owner's Manual

Blade tracking knob_
_,Blade tension knob
_ Ig knob
Motor
Lock swi
4" Dust
1. CENTERING THE TABLE
a. Loosen the four hex. bolts mounting the table to the upper table
trunnion. (See FIG. 11)
b. Move the table sideways as required, until the saw blade runs
through the center of the table insert.
c. If the adjustment of "b" is not enough to center the table, loosen
the four flange nuts holding the lower table trunnion and move the
table sideways to place the table in the center.
d. Re-tighten hex. bolts for trunnion, recheck the saw blade
position.
c. Tighten the hex. nut and recheck the saw blade and the table for
squareness.
d. Lock the table into position and check that the indicator reads
zero degree on the side of lower table trunnion. Loosen the screw
securing the indicator and reset if necessary to give zero degree
reading. (See FIG. 13)
2. SETTING TABLE SQUARE TO SAW BLADE ON
RIGHT AND LEFT POSITION
Loosen the wing nut on the lower table trunnion and place a
suitably sized square against the saw blade on right and left
position. If the table requires adjustment, proceed as follows:
a. Using a wrench, release the hex. nut on the frame. (See FIG.12)
b. Place the wrench on the hex. bolt and adjust until the table
square to the saw blade.(See FIG.12)