Advertisement
MITER TABLE CLAMP
See Figure 4.
The miter table clamp securely locks your saw at
desired miter angles.
SAWARM
MITERTABLE
CLAW' O N
Posmo_
TRIGGER
LOCK
See Figure 6.
To prevent unauthorized use of your compound miter
saw, we suggest that you disconnect it from the power
supply and lock the switch in the off position. To lock
the switch, install a padlock through the hole in the
switch trigger, A lock with a shackle up to 13/64 in.
diameter may be used. When the lock is installed and
locked, the switch is inoperable. Store the padlock key
in another location.
SWITCH
TRIGGER
PADLOCK
Fig. 4
_
Fig. 6
LOCK-OFF
LEVER
See Figure 5.
The switch trigger is equipped with a lock-off lever to
reduce the possibility of accidental starting. The lock-
Off lever must be pressed down with the palm of your
hand to turn the saw on. The spring loaded lever will
spring back into the lock-off position when the switch
trigger is released.
LOCK-OFF
LEVER
POSITIVE
STOPS
ON
MITER
TABLE
Positive stops have been provided at 0 °, 22-1/2 ° and
45 °. The 22-1/2 ° and 45 ° positive stops have been
provided on both the left and right side of the miter
table.
BEVEL
LOCK
KNOB
The bevel lock knob securely locks your compound
miter saw at desired bevel angles. Positive stop
adjustment screws have been provided on each side
of the saw arm. These adjustment screws are for
making fine adjustments at 0° and 45 °. See pages 17
and 18.
TRIGGER
Fig. 5
11
Advertisement
