Advertisement
HOW TO SET UP YOUR
UNIT
Location
of the Air Compressor
•
Locate the air compressor
in a
clean, dry, and well ventilated
area,
•
Locate the air compressor
at
least 12" away from the wall or
other obetruc'tions that will
interfere with the flow of air.
•
Locate the air compressor
as
close to the main power supply
as possible to avoid using long
lengths of electrical wiring.
NOTE: Long lengths of electrical
wiring could cause power loss to
the motor.
•
Tr_e air filter must be kept clear
of obetruc'tions which could
reduce air flow to the air
compressor.
Anchoring
of the Air
Compressor
Excessive Vibration
can weaken the air
tank and cause an explosion. The
compressor must be properly
mounted.
Tr_e air compressor
MUST be bolted
to a solid, level surface.
Hardware needed:
4 - Concrete anchors (not supplied)
4 - 3/8" Lag screw to fit concrete
anchors (not supplied)
4 - 5/8" Washer shims (found in
parts bag, if needed)
1,
Place the air compressor
on on a
solid, level surface,
2,
Mark the surfaes using the holes
in the air compressor feet as a
template,
3,
Drill holes in the surface for the
concrete anchors. Install
concrete anchors.
4,
Une-up holes in surface with
holes in air compressor feet.
5,
Place the (4) washers (not
supplied) between the floor and
air compressor feet, If needed,
solid shims may be placed
between the washers and floor to
evenly distribute weight on all
four feet, See next figure.
3/8' Lag
_rew
(net
--_--
Surface Line
Shim Under
Washer
Concrete Anchor
[not supplied)
(not supplied)
6,
Place the (4) 3/8" lag screws
through the air compressor feet,
washers, shims, and into the
anchors,
7,
Torque 3/8" lag screws to 7-10
fL-Ibs,
11-ENG
L33CC9_2
Advertisement
