Connect Control Cables; Install Shifter Rod; Headlight - Craftsman 536.886220 Owner's Manual

CONNECT CONTROL CABLES
• Remove wrap
from upper handle which
was used to protect clutch levers.
NOTE: If control cables have become
unattached from motor mount frame,
reconnect cables as shown below_
Traction drive Auger drive
spring (Long) spring (Short)
Auger
drive
spring
cable
View from the left side of unit
gear position
Speed
Select
Bracket
Control Rod
I lever
• Connect control cables to control lever
as shown in figure below.
NOTE: The control cables attached to the
auger clutch lever and traction clutch lever
may need to be adjusted before you use
your snow thrower
Z" Fitting
For instructions on checking or adjusting
the control cables, (See To Adjust Clutch
Control Cables paragraph on page 19).
• Roll the snow thrower off the skid by
pulling on the handle
, Properly dispose of discarded packing.
INSTALL SHIFTER ROD
(set aside earlier)
• Place speed shifter Iever into sixth gear
position.
• Insert speed control rod (the end with the
90 ° bend) into the speed select bracket
lower hole, see next figure
• Attach speed control rod to the speed se-
lect bracket with one flatwasher and one
cotter pin found in parts bag, see next
figure _
o Move speed shifter lever into R 1position,
Remove Iockwasher and nut from ball
joint, see next figure
Attach ball joint to speed select lever with
lock'washer and nut, then tighten. See
figure below. The speed control rod and
ball joint have been preadjusted at the
factory and should not require readjust-
ment.
Speed
Control T..m--_
Ball Joint
# _ 1I _',-_'-m'" Lever
HEADLIGHT
• Rotate headlight into operating position
as shown in figure below.