Install Mid-Chute Rod - Craftsman 536.886220 Owner's Manual

_onnect "Z" fitting into remote chute
'.ontrol bracket as shown in figure below.
:mote
_ute Remote Chute
_ntrol Bracket
acket
JmoteChute
Control Cable
Mid.Crank
Rod
Rod
Push remote chute control lever into
"Chute Deflector Down" '_ position.
,it
Cut tie strap on chute deflector as shown
in figure below.
hute
eflector
',ISTALL MID-CHUTE ROD
;et aside earlier)
Carefully remove cotter pin and clevis
pin from universal joint in the upper crank
rod as shown in next figure.
_OTE: If this removes the universal joint
_nd universal joint pin, Place universal joint
._to yoke of upper crank rod lining up large
iotes, Insert universal joint pin (ensure
_pening in universal joint pin is in line with
;mall openings in universal joint).
_' Upper
C,evis Pin------'-'_/ -"'Crank Rod
Jniversal Joint _'_'''_ Universal
_._ Joint Pin
-'_ Cotter Pin
• Place yoke of open end of mid-crank rod
around universal joint in upper crank rod.
Insert clevis pin through assembly and
secure with cotter pin. Spread ends of
cotter pin to lock in place, See figure
below,
• Cut tie securing the lower crank rod to the
chute rod bracket. See second figure
below.
- Carefully remove cotter pin and clevis
pin from universal joint in lower end of
mid-crank rod as shown in figure below.
NOTE: If this removes the universal joint
and universal joint pin° Place universal joint
into yoke of upper crank rod lining up large
holes° Insert universal joint pin (ensure
opening in universal joint pin is in line with
small openings in universal joint).
---.__ Universal Joint Pin
Lower End_"_.._-_ .... j Universal Joint
of Mid- "1/_ _
Cran_
a
Slide universal joint in mid-crank rod into
yoke of lower crank rod, insert clevis pin
through assembly and secure with cotter
pin. Spread ends of cotter pin to lock in
place, See next figure_
Cable Tie
Chute
Bracket
Mid-Crank
Rod
Lower