Upper Handleand Crank Assembly; Connect Control Cable Springs - Craftsman C950-52930-0 Owner's Manual

Dual stag snow blower 11-h.p. 31 inch
Hide thumbs Also See for C950-52930-0:
Table of Contents

Advertisement

ASSEMBLY
UPPER
HANDLEAND
CRANK ASSEMBLY
1.
Loosen, but do not remove the screws, flatwashers, lock-
washers and hex nuts in the upper holes of the lower han-
dle.
2.
Raise upper handle into operating position.
Upper han-
dle should be to the outside of the lower handle.
.
NOTE: Make sure the cables are not caught between
the upper and lower handle.
Install hardware supplied in the parts bag (screw, flat-
washer, lockwasher, and hex nut) into right lower hole of
upper handle (See Figure 6 ). Do not tighten until all bolts
are in place.
4.
Locate crank assembly removed from carton earlier and
remove the 3/8" nylon locknut and fiatwasher from the
eye bolt assembly.
5.
Install the eye bolt through the lower hole on the left hand
side of the handle. (See Figure 6).
6.
Install the 3/8" flatwasher and the 3/8" nylon locknut.
7.
Carefully remove cotter pin, clevis pin, and universal joint
pin from yoke end of crank rod assembly. (Figure 7)
8.
Place universal joint into end of worm gear lining up large
holes. Insert the universal joint pin. Make sure the open-
ing in pin is in line with small openings in universal joint.
9.
Place yoke end of crank rod around universal joint lining
up openings. Insert clevis pin through assembly and se-
cure with cotter pin. Spread ends of cotter pin to lock in
place.
10. Tighten nut on eye bolt, keeping eye in line with the rod
while tightening the inside securely.
11. Tighten all handle bolts.
NOTE:
Make sure crank does
not touch
carburetor
covet.
Adaptor
Eye Bolt
\
3/8-18 x
_-
2" Bolt
3/8"
Lockwasher
_
3/8 Nut
\
11/32 "Flatwasher
Flatwasher
Figure 6
iI
"
Cotter Pin
LL
iA
Clevis Pin
Universal Joint
Crank Rod
Assembly
Drilled Pin
Figure 7
CONNECT
CONTROL
CABLE SPRINGS
1.
If control cable springs have become unattached from
motor mount frame, reconnect
cables as shown in
Figure 8.
2.
For cable adjustments,
see "Cable Adjustment"
in the
ADJUSTMENT/REPAIR
section.
3.
Roll snow blower off the skid by pulling on the handles.
Figure 8
F-001008J
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents