Radial Arm To Base Assembly - Craftsman 113.234700 Owner's Manual

Assembly
Radial Arm to Base Assembly
1. Back out column retaining screw
from base enough so column can clear
when inserted.
2. Unlock miter lock. Pull out miter
index pin and turn 90° to lock out.
3. Get grease packet. Being careful of
sharp edges which may be present in
base opening, evenly spread grease
around inside of base opening. Notice
shoulder at bottom of base.
Miter
Unlock Lock
Column
Retaining
Screw
4. Insert column into base opening,
pushing down until colunm goes all the
way down to rest on shoulder at bottom
of base.
__?_11;_ Base Opening
5. Wrench tighten column retaining
screw.
6. Turn miter index pin 90° to allow it to
engage indexed position.
7. Lock miter lock.
18