"One-To-One" Service - Chery SQR7240T User Manual

The new tires don't have the best adhesion
at the beginning of use; therefore, the tires
also need run in. The vehicle speed should
be relatively low during the first 100km
driving and the driving should be
extremely careful.
The new brake friction lining also needs
run in, since the brake doesn't have ideal
friction force during the first 200km
driving. During this period the brake
effects are a little poor, therefore the
pressure on brake pedal may be reasonably
increased. Such condition
applicable each time the friction lining is
replaced with a new one.
When the new vehicle traveled for 800km,
the wheel nuts must be re-tightened to the
specified torque. Please refer to the
chapter ―Capability and Specification
Parameters‖ of this manual for correct
torque values. Also, if the wheel has been
replaced or the wheel nuts have been
loosened, then the wheel nuts should be
re-tightened in accordance with the
specified torque after traveling for 800km.

"One-To-One" Service


In order to provide you with better service
and vehicle use, the dealer of Chery
Company will
consultant to serve you at the purchase of
your vehicle. In case of any problems
during your vehicle use, you may contact
your service consultant, who will provide
you with the best services.
is also
appoint one service
Introduction