Safety Tips - Chery SQR7240T User Manual

Driving
Start
Preparations prior to start
Starting of engine is controlled by electric
control system of engine.
Don't step on the gas prior to, and during
starting of an electro-jet engine. Use the
throttle only when there are difficulties in
starting. See ―Starting of engine‖ of this
chapter for details about how to start a car.
Racing of engine for long
results in overheating
engine and exhaust system to
produce hazards of fire disasters and
other damages.
Don‟t park, run idle or drive
on the pavement covered with
dry grass or other dry articles.
Exhaust system causes
temperature of power plant nacelle
and exhaust pipe to result in ignition
possibly.
Don‟t start a car in airtight
garage or other airtight places
due to toxic nature of tail gas
emitted by automobile. Open the
garage door necessarily before engine
is started. See "Caution against
exhaust fume" of this chapter for
details.
If there is a smell of exhaust
fume in your car, please turn
to Chery chartered service
station for inspection. Continuous
driving is forbidden.
of

Safety tips:

Idling speed of engine is controlled by
electric control system. The idling speed is
high when the engine is started to facilitate
temperature
temperature of engine rises, the idling
speed should be reduced automatically. If
rise of
the idling speed can't be lowered down,
rise of engine. When
Driving
send the car to Chery chartered service
station for inspection & repair. Running of
engine at a rate higher than rated idling
speed for over 10 minutes is forbidden.
Before the car is started:
1. Confirm that all occupants wear safety
belts well. See the chapter ―Seat and
Safety Protection‖ for details about
safety belt and usage.
2. Confirm that head light and other
electrical fittings are switched off.
3. Confirm that hand brake is pulled up.
4. Confirm that the selector rod is at the
position ―P‖ (parking)
(Automatic Transmission) cars.
Engine is started only when the AT
selector rod is at the position ―N‖ or ―P‖.
Your car is configured with an additional
locking device of selector rod, which
functions when the selector rod is at the
position ―P‖.
for AT