Chery SQR7240T User Manual page 147

Step on the foot brake and push the
locking button to displace the selector rod
after the engine is started.
5. Confirm that the selector rod is at a
neutral position for MT cars.
6. Twist the ignition switch to ―ON‖
instead of ―START‖.
If it is hard for the key to be rotated, rotate
the steering wheel to the left or right until
the key can be smoothly rotated. There
might be the factors below for such a case:

Front wheel deflection.

Front wheel hits upon road edge.

The steering wheel is rotated when
you get on/off a car.
7. Determine if the warning indicator of
instrument panel is ON for a short
period while ignition key is turned on;
if the warning indicator is not ON,
turn to Chery chartered service station
for inspection & repair.
If driver‟s safety belt has been well
fastened before the ignition key is
turned on, the warning indicator for
safety belt won‟t be illuminated.
To start an engine
1. Twist the ignition switch to the
position START. Don't step on the gas.
Loosen your key immediately when
the engine is started, and the key will
be back to the position II.
2. If the temperature is higher than -12C
and the engine can't be started within
5 seconds the first time, twist the key
to the position OFF and try again after
10 seconds.
3. If the temperature is lower than -12C
and the engine can't be started within
15 seconds the first time, twisted the
key to the position OFF and try again
after 10 seconds. If the engine can't be
started for two times continuously,
step on the gas to the bottom and hold
on, and twist the key to the position
START. Loosen the key after the
engine is started; and then, loosen the
accelerator pedal slowly along with
heightening of engine speed.
4. For AT cars, run idle for several
seconds after the engine is started and
then, step on foot brake and loosen
hand brake to shift in the running gear
and to be ready for running.
Pull up the hand brake or
step on the foot brake
before gear
Otherwise, automobile may move
during gear shift to result in
damages.
5. For MT cars, run idle for several
seconds after the engine is started and
then, step on the clutch, shift in the
running gear and loosen hand brake to
be ready for running.
6. For MT cars, the reverse gear can be
shifted in, only when the gear shifter is
pushed down when the vehicle is at
rest. Step on the clutch pedal to the
bottom before gear shifting and shift
the gear appropriately after a few
seconds so as to prevent the bad gear
coupling of transmission
producing the noise of quack lingo,
when the engine is running. When
ignition switch is put through, the
reversing light of rear end will be ON
immediately when the reverse gear is
shifted in.
Driving
shift.
from