Preparation Before Starting; Safety Notice - Chery A1 2008 Operating Instructions Manual

Start
PREPARATION
BEFORE STARTING
The engine's starting is controlled by an
electric control system.
When starting an electronic injection
engine, do not push down the accelerator
pedal before and during the starting. Use
the accelerator pedal only when it is
difficult to start the engine. For more
information about the car's starting, see
"Starting" in this chapter.
INTRODUCTION OF DRIVING
The engine's long high-speed
racing could cause the engine and its
exhaust system to overheat and has
chance to cause fire and other
damages. Therefore, do not park on
the ground with hay or other dry
coverings.
The tail gas exhausted from
the vehicle is toxic, so, do not start a
car long in an in-closed garage or
other closed places. Be sure to open
the door of the garage before starts
the engine. See "Beware of the Car's
Exhaust Fume" for more information.

SAFETY NOTICE

The engine's idle speed RPM is controlled
by an electric control system. The engine
starts with a higher idle speed RPM so as
to raise its temperature. The idle speed
RPM should automatically fall after the
engine reaches a proper temperature.
Deliver the car to Chery Authorized
Service Station for repair if the idle speed
RPM could not fall automatically. Do not
let engine run for more than 10 minutes at
a speed higher than specified idle speed.
MATTERS
CONCERNED
BEFORE STARTING
YOUR VEHICLE