Brake; Abs - Chery QQ3 User Manual

putting into gear, accelerate a little and
shift again.
！Notice:
If you want to start on a brae, you must
pull the parking brake and step slightly
down the accelerator panel, loosing the
parking brake at the same time. Do not
start the car with the hood open.

Brake

The conventional brake is designed to
satisfy the performance under all kinds of
circumstances (including fully loaded).
Your car is equipped with diagonal
crossed brake system. The front wheel is
equipped with disc brake, and the rear
wheel is equipped with drum brake.
If the first brake oil path failed, the car
can still brake with the second oil path.
When this happens, you need to step on
the brake pedal with more strength. The
brake distance will be prolonged. Please
go to the Chery Service Station to check
the brake system before continuing with
your drive.
If the brake pedal is lower than before,
you need to adjust the rear drum brake. If
this happens, please test your car forward
and backward and test the brake in all
directions to find out the reason.
If the pedal does not get back or the
distance is too long, please cont act with
Chery Service Station, because this
probably is a signal for the fault in brake.
！Notice
The brake might invalidate if it is
overheated. So 1、 Use engine brake under
low gear when driving
declivity2 、 Do not use the brake
continuously.
If the components of the brake are hu mid,
the brake will not function for a while. So
take a look at behind for any other cars
Start and Operation
and step slightly on the brake pedal to
check whether the function has lost. Then
keep the distance with other cars for
enough space, and step slightly on the
brake pedal until it get back to work.
When crossing water (which is deep
enough to wet the components) or after a
washing, repeat the above process to
avoid any accident. The brake friction
piece and the brake cushion might be
worn, so do not lay your feet on the brake
pedal during driving.

ABS

ABS is a kind of advanced
electric brake system which can
prevent the car from sliding during
a brake.
ABS is to prevent the wheel from locking
in an emergent brake or on a smooth road,
down a
and to keep the swerving and stability of
the car.
This system use sensor to detect the
differences amon g each wheel speed and
begin to function when the wheel is going
37