Chery QQ3 User Manual page 69

once, and then the brightness level will
return back to the minimum value.
● Clock's integral point calibration
In case that the clock displayed is within
the integral point to or past 2 minutes,
press the "TRIP" and "SEL" buttons at
the same time to calibrate the integral
point of the clock. For instance: When the
time displayed is 14:59 but the actual
time is just 15: 00, this calibration
op eration can immediately calibr ate the
clock to 15:00.
● Setting
The following functions
implemented only after entering the
setting status.
● Enter the setting status
Press the key "SEL" for 2 s to enter the
setting status. In this case, the "SET"
mark on the odometer flashes, which
indicates that the instrument has entered
into the setting status.
● Exit from the setting status
In case of setting status, if press the key
"SEL" for 2 s or 15 s and do not carry out
any other operation, the instrument exits
from the setting status and the mark
"SET" extinguishes.
1. Clock initialization
In case that the mark "SET" flashes,
simultaneously press the "SEL" and
"TRIP" buttons once for a short time to
enter the clock initialization mode. In this
case, the Hour digital flashes. Press the
"TRIP" button to adjust the value of Hour
digital, with the increment every a press.
If press the "TRIP" button and keep it,
the Hour digital increases automatically
till the Hour digital is right; if it is
unnecessary to adjust the Hour value,
directly press the "SEL" button to enter
can be the M inute adjustment status. In this case,
the Min digital flashes. Press the "TRIP"
button to adjust the value of M in digital,
with the increment every a press. If press
the "TRIP" button and keep it, the M in
digital increases automatically till the
M in digital is right.
After the completion of adjustment,
simultaneously press the "SEL" and
"TRIP" buttons for a short time to
complete the clock setting.
1. Daytime display brightness setting
Press the "SEL" button to enter the
setting status. The SET code is displayed
as follows:
Instruments and control devices
It means that in the case of "Daytime
Display Brightness" setting status, the left
two digitals
brightness setting status mark while the
right three digitals represent the set value
which can be selected from 1 to 100 and
the initial value is max. 100. Press the
"TRIP" button once to decrease the value
by 10. For instance: To adjust the
brightness to 85, its operation procedure
is as follows: Press the "TRIP" button t ill
the value displayed is 90, and then release
the button and press the "TRIP" button
five times to get the brightness of 85.
2. Nighttime
adjustment
Press the "SEL" button to enter the
setting status. The SET code is displayed
as follows:
represent the daytime
display brightness
60