Charmglow Gas Grill Owner's Manual page 12

Table of Contents

Advertisement

Available languages

Available languages

LIGHTING THE SIDE BURNER:
1.
2.
3.
Open lid before lighting side burner.
Make sure control knob is in the "OFF" position.
Push and turn side burner control knob to the "HIGH"
position.
4.
Press the electronic
igniter
on the main control
panel
and hold for 3-5 seconds
to light burner.
5.
If ignition does NOT occur in 5 seconds,
turn control
knob to "OFF", wait 5 minutes to allow gas to dissipate
and repeat lighting procedure.
6.
To turn off, turn each control knob clockwise
until it locks
in the "OFF" position.
Note:
If burner does not light or flame is too low, you may have spider or other insect blockage
in
burner, or the flow limiting device has been activated.
See "Burner Assembly/Maintenance"
under Proper Care and Maintenance,
or "Regulator
Resetting
Procedure"
under Connecting
LP Cylinder and Hose/Regulator
to Grill.
MATCH LIGHTING THE SIDE BURNER:
1.
Open the lid to the side burner before lighting.
2.
Turn the burner control knob to "OFF".
3.
Strike and carefully
place a match approximately
1/2" (1 to 2 cm) from the burner.
4.
Turn the side burner control knob to the "HIGH" position. The burner should light within 5 seconds.
5.
If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate
and
repeat lighting procedure.
6.
If the burner does not light within the first few attempts
of match lighting, there is a problem
with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate
the grill until the
problem
is found and corrected.
See "Trouble Shooting"
section of this manual.
Note:
Observe
flame height
when lit: Flame
should
be a Blue/Yellow
color between
1 "-2" when
burner is on "HIGH".
TURNING OFF THE GRILL:
1.
Turn off the cylinder valve.
9
--
2,1
--
1 II
--
0
n
2.
Turn all burner control knobs to the "OFF" position.
Note:
Turn off LP cylinder first to prevent gas from being left in the system under pressure.
ACAUTION!
The cylinder valve should always be in the off,
or closed, position when the grill is not in use.
To turn off the cylinder valve,
turn knob clockwise until it stops,
tt

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents