Pre-Start Check List - Charmglow Gas Grill Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

6.
Check each place listed (A-K) for growing
bubbles which indicates
a leak.
7.
Turn off gas supply at cylinder valve.
8.
Turn on control knobs to release gas pressure
in hose.
9.
Turn control knobs to "OFF" position.
10. Tighten any leaking connections.
11. Repeat soapy water test until no leaks are detected.
12. Turn off gas supply at cylinder valve until you are ready to use your grill.
13. Wash off soapy residue with cold water and towel dry.
14. Wait 5 minutes to allow all gas to evacuate
the area before lighting grill.
,_, CAUTION!
DO NOT use the grill if leaks cannot be stopped.
Contact a qualified
gas appliance
repair service.
Note:
The leak test must be performed
in an area that has adequate
lighting in order to see if
bubbles are developing.
PRE-START CHECK LIST:
Property damage,
bodily harm, severe
burns, and death could result from failure
to follow
these
safety
steps. These steps
should
be performed
after the grill has been assembled
and prior to each
use. DO NOT operate
this grill until you have read and understand
ALL of the warnings
and
instructions
in this manual.
PRE-START CHECK LIST:
Ensure that the grill is properly assembled.
Inspect the gas supply hose for burns, chaffing, kinks, and proper routing before each use. If it is
evident there is excessive
abrasion
or wear, or the hose is cut, it must be replaced
prior the grill being
used. Replace with hose and regulator,
Model No. 155-2400-0,
which can be obtained
by contacting
customer
service at 800-527-0717.
Leak check all gas connections
and hose. See section on "Leak Testing".
Ensure that all electrical
supply cords are properly
grounded.
Keep any electrical
supply cord and the
fuel supply hose away from any heated surfaces.
Hose should be at least 3 inches from hot surfaces.
Position your grill on level ground in a well ventilated
location, a safe distance from combustible
materials,
buildings
and overhangs.
Properly
place the empty grease tray under the grease drain hole in the bottom of the grill to catch
grease during use.
DO NOT obstruct the flow of combustion
and ventilation
air.
9

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents