Epson Stylus Photo 2000P Printer Basics Manual page 53

P is on
S
flashes
S
is on
B A
or flash
B A
or are on
S
P and
flash
and
B A
and are on
S
B A
P
flash
S
B A
P
are off
48
The Ppower light is on when the printer is ready to print. It flashes
when the printer is receiving a print job, charging ink, or cleaning the
print head.
When the S paper out light flashes, you have a paper jam. Press the
E load/eject button to try to clear the jam. If that doesn't work, turn off
the printer and gently pull out all the paper. Make sure none of the
sheets are curled, creased, old, stuck together, or too thin. Then reload
the paper against the right edge guide and slide the left edge guide
against it. Turn on the printer and press the E load/eject button to
resume printing. (If you're using roll paper, see page 28 for additional
loading instructions.)
When the S paper out light comes on, your paper is out or incorrectly
loaded. Make sure none of the sheets are curled, creased, old, stuck
together, or too thin. Then reload the paper against the right edge
guide and slide the left edge guide against it. Press the E load/eject
button to resume printing. (If you're using roll paper, see page 28 for
additional loading instructions.)
When an ink out light flashes, your ink supply is low. Make sure you
have a replacement cartridge.
When an ink out light comes on, you need to replace the ink cartridge.
Make sure you have a replacement cartridge. See page 40 for
replacement instructions. If an ink out light comes on after you've
replaced a cartridge, you installed a cartridge your printer can't use.
Remove it and replace it with the correct type.
When the Ppower and S paper out lights flash, and both of the ink out
lights come on, jammed paper may be blocking movement of the print
head. Turn off the printer, open the cover, and check inside for any
jammed paper. Then turn the printer back on. If the lights still flash and
come on, contact your dealer or EPSON; see page 59 for information.
When all the lights flash, your printer may have an internal error. Make
sure you removed all the packing material as described on the Start
Here poster in your printer box. Then turn off the printer, wait a few
seconds, and turn it on again. If the lights still flash, contact your dealer
or EPSON; see page 59 for contact information.
When all the lights are off, the printer is not receiving power. Try these
solutions:
Make sure the printer is turned on.
Turn off the printer, plug in the power cord securely, and turn on
the printer again.
Make sure the outlet is operable and is not controlled by a switch
or timer. If in doubt, try using another outlet.