Epson Stylus Photo 2000P Printer Basics Manual page 34

4. Insert the roll paper onto the
spindle, making sure it's
oriented as shown here. Then
place the spindle with the roll
paper onto the holder.
5. Load the end of the paper into the printer as far
as it will go, then slide the left edge guide against
the paper.
6. Gently hold the paper in place as you press
and release the E load/eject button to feed the
paper into the printer. Avoid handling the
paper excessively to prevent contamination
with dirt or grease.
(If the paper doesn't feed properly, lift the
paper out and then reload it. If the paper
doesn't come out easily, hold down the
E load/eject button for three seconds. Then
turn the printer off, remove the paper, and
turn the printer back on to reset it. When reloading, make sure the end is cut
straight and not curled or damaged. If necessary, re-trim the paper as shown in
step 1.)
7. Make sure the output tray is open but the extensions are closed, and leave ample
room at the front of the printer for your paper to eject smoothly.
8. Follow the steps in the next section to print on the roll paper.
29