Service; General; Cutting Fluid System - Shop fox M1014 Instruction Manual

General

This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
tech-support@shopfox.biz.

Cutting Fluid System

Cutting fluid is usually poisonous and can be a biological
hazard! Always use the correct personal protection
equipment when working with cutting fluids, pumps,
fittings, and lines.
Maintain the cutting fluid system as follows:
• Reservoir and Pump: Remove four screws and the
pump from the reservoir every six months and clean
sludge from the tank and remove any restricting
material around the pump intake (see Figure 45).
• Screens and Lines: Inspect fittings and lines for
leaks and kinks, and repair as required. Make sure
all screens are unclogged.
• Electrical: Unplug and inspect electrical switches
and wiring for potential shorting with liquids and
repair as required.
M1014 7" x 12" Metal Cutting Bandsaw

SERVICE

MAKE SURE that your machine is
unplugged during all service proce-
dures! If this warning is ignored, seri-
ous personal injury may occur.
-30-
Pump
Intake
Port
Figure 45. Pump intake port.