Table of Contents
Advertisement
This function enables you to set a recording
length simply by pressing the REC/OTR button
on the TV/VCR.
Make sure:
. TV/VCR power must be turned on.
o Insert a cassette tape with its erase
prevention tab in place. (If necessary, rewind
or fast forward the tape to the point you want
to begin recording.)
NOTE:
This function CANNOT be done from the
remote control.
,_ Recording starts immediately when the
REC/OTR button is pressed.
o When the REC/OTR button is pressed 18
times, the TV/VCR returns to the Normal
Recording mode.
_, To stop the OTR operation, press the STOP
button on the TV/VCR or on the remote
control.
To show the remaining time, press the
DISPLAY button on the remote control so that
"OTR" appears on the TV screen (It wil! show
up momentarily then disappear.)
o Recording stops when 0:00 is reached.
,J Please note that in the SLP mode, maximum
recording time, is 8 hours using a T-160 or 6
hours using T-120 tape.
e If the tape runs out before the end time, the
TV/VCR will switch to the Stop mode
immediately, ejects the tape and turns itself off.
_!_!
U
,2
C!¢i'i
!.i
L C_
_!'•_
i_
Press the number buttons on the remote control
or the CHANNEL UP or DOWN button.
Remember:
If the TV/VCR is connected to a
cable box or satellite box, the TVNCR must be
on CN3 or CH4, then the channel to be recorded
is selected on the cable box or satellite box.
Press the SPEED button to select the desired
tape speed (SP/SLP).
Press [he REC/OTR blJ[ton
I/_I;II:;
once
to begin
recordieg.
Press twice to set recording length to 30 minutes.
Each additional push of the button will increase
the recording time by 30 minutes, up to a total of
480 n'finutes.
Push(es)
i Display
]
Recording
length
,
lp£sh
I
(Begin:Recording)_
2 pushes
0:30
30 m!nutes
3 pushes
i
1:00
60 minutes
._
'
,L
17 pushes i
8:00
480 minutes
Unauthorized
recordings
of copyrighted video tapes may be an
infringement
of copyright
laws,
Connect your TVNCR and a Source (Playing) VCR
using the following diagram.
[The TVNCR]
[Ex: Source (Playing) VCR
or camcorder]
Audio/Video
adapter cable
(not supplied)
(_
1) insert a pre-recorded video cassette into the
Source (Playing) VCR or camcorder.
2) Insert a blank video cassette, or one you want
to re_,_,,,,; o ver, irtto the 1 V/VCR's cassette
compartment.
3) Press the SPEED button on remote control for
the TV/VCR to select the desired recording
speed (SP/SLP).
4) Press the CHANNEL UP or DOWN button on
the TV/VCR until "AUX" appears on the
screen.
5) Press the REC button on the TV/VCR.
6) Begin playback
of the tape in the source
(Playing)
VCR or camcorder
NOTE:
For best results during
copying,
use the
TV/VCR's
fron! panel controls
whenever
possible.
The remote controt
might affect the
source (Playing)
VCR's playback
operation
- 24
EN
6K03
Advertisement
Table of Contents
