Table of Contents
Advertisement
8. Timer recording begins as sched-
uled, but the channel is always
incorrect.
9. We moved, and now VCR Plus+
doesn't work properly.
10."PROGRAM
FULL" is displayed on
the VCR Plus+ screen.
• Even though you don't use an
external Cable Box, "CABLE BOX
OUTPUT" is set to "ON".
• The receivable stations in the new area
are received on different channels than
those in the previous area.
I
et "CABLE BOX OUTPUT" to "OFF"
(_
pg. 16).
I
e-perform the VCR Plus+ setup
procedure ([]_:_pg. 19).
o]1l,I1 1
innlnmlnNmnnl
1. When scanning channels, some of
them are skipped over.
2. The channel can't be changed.
3. The remote control won't operate
my TV.
4. The remote control won't operate
my cable box.
5. Even though Auto or Semi-Auto
clock setting has been selected, the
clock is incorrect.
• Those channels have been preset to
be skipped.
• Recording
is in progress.
• The TV/CABEE/VCR
switch
is set to
a position
other
than TV.
• The TV/CABLE/VCR
switch
is set to
a position
other
than CABLE.
• The clock
setting data received
from
the Host Channel
is incorrect•
I
I
I
I
If you need the skipped channels,
restore them (0:_ pg. 14).
Press PAUSE to pause the recording,
change channels, then press PLAY to
resume recording.
Set the switch
to TV.
Set the switch to CABLE.
Select a different Host Channel during
the Semi-Auto setting procedure
(_:_ pg. 10), or perform the Manual
setting procedure 0_" pg. 11).
ATTENTION:
This recorder contains microcomputers.
External electronic noise or interference could cause malfunctioning.
In such cases,
switch the power off and unplug the power cord. Then plug it in again and switch power on. Take out the cassette. After
checking the cassette, operate the unit as usual.
Advertisement
Table of Contents
