Table of Contents
Advertisement
Mounting range hood without cabinet
Chimney Installation Chart (optional)
1
Install the range hood
to the desired position
6
Slide the chimney
(upper + lower)
into the base
Tape all joints in ducting and all gasketed opening on hood for a tight seal.
Note:
7
Check 2 screw holes
1.Duct cover and extension duct cover fitment may vary depend on the mounting height of
Note:
the range hood.
2.Make sure you can easily peel the white protection pvc film after installation, otherwise
please peel it before chimney installation.
2
Check and fix the
ower chimney
bracket
5
Install the 6" piping tube or
7" piping tube (Ref fig 3-2
use converter), or rectangular
piping exhaust outlet.
Note:
all piping tubes are not
included.
8
Fasten 2 screws
15
3-1
1. Set 6" round ducting
collar or
2. Set rectangular starting
collar (check manual)
4
Check the desired length of
chimney and mark the position
for upper chimney bracket then
fixed. each section 19-1/2" (50cm)
in length maxi extention length
38" (96.5cm)
9
Extend the upper chimney
up to the desired position
3-2
oor
7" round converter collar
(for 7" exhaust piping)
?
10
Check 2 screw holes
and fastened
(complete finished)
Advertisement
Table of Contents
