Table of Contents
Advertisement
PROBLEM
No power, nothing runs
Vacuum motor will not
run
Vacuum motor runs but
suction is poor
Poor or no water flow
(carpet is streaky)
Brush does not spin
Accessory tool fitting
difficult to connect
CAUSE
Is the cord plugged in.
Circuit breaker tripped in building.
Faulty switch.
Faulty power cord or pigtail.
Vacuum circuit breaker tripped.
Faulty main switch.
Loose wiring.
Faulty vac motor.
Debris lodged in vac shoe.
Dome gasket defective or missing.
Vacuum hose cracked or hose cuff loose.
Recovery tank full.
Switch to accessory mode.
Jets clogged or missing.
Solution filter clogged.
Faulty solution pump.
Switch in accessory mode.
Brush circuit breaker tripped.
Brush belt broken.
Faulty brush motor.
Corrosion on fitting.
86037780 EXTRACTOR 12/09/06
MAINTENANCE
TROUBLESHOOTING CHART
SOLUTION
Plug in cord.
Reset breaker
Call for service.
Call for service.
Reset breaker
Call for service.
Call for service.
Call for service.
Remove debris from vac shoe.
Replace as necessary.
Replace or repair as necessary.
Turn off vac motor. Drain and rinse
recovery tank.
Turn to deep clean position.
Clean using a vinegar /water solution or
replace.
Drain solution tank and clean solution
filter.
Call for service.
Turn to deep clean position.
Reset circuit breaker.
Replace as necessary.
Call for service.
Clean with steel wool.
Remove and soak in acetic acid (white
vinegar).
Lubricate lightly with silicone base
lubricant.
4-5
Hide quick links:
Advertisement
Table of Contents
