Operating Instructions - Windsor MPRO 10080390 Operating Instructions Manual

OPERATING INSTRUCTIONS

FILLING THE SOLUTION TANK
1. Release dome clamp.
2. Lift upper recovery tank from machine and
set aside.
3. Use a clean bucket, recovery tank or hose to
fill solution tank with hot water. The solution
tank holds 4 gallons (15.2 liters) of cleaning
solution.
4. Add a non-foaming concentrate for use in
hot water extractors at the proportions noted
on the container.
NOTE: Periodically operate the extractor with only
hot water to remove chemical residue in carpet.
To avoid possible distortion of the polyethylene
solution/recovery tanks, DO NOT USE WATER
WITH A TEMPERATURE THAT EXCEEDS 140°F
(60°C).
5. Place recovery tank back on machine.
6. Place dome on recovery tank. Make sure
dome is seated correctly to ensure proper
vacuum seal. Clamp dome securely to
recovery tank.
Use only the suitable chemicals listed in the
Chemical Section. Using incompatible
chemicals will damage the machine. Carefully
read ingredients on manufacturer's label before
using any product in this machine.
SPECIAL NOTES:
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with
the appliance.
The sound pressure level at the operator's ear was
measured to be 73.7 dBA. This was a nearfield,
broad-band measurement taken in a typical
industrial environment on a tile floor. This appliance
contains no possible source of impact noise. The
instantaneous sound pressure level is below 63 Pa.
The weighted root mean square acceleration at the
operator's arms was measured to be below 2.5m/s
This was a tri-axial, third-octave-band measurement
made during normal operation on a composite tile
floor. The measurement and related calculations
were made in accordance with ISO 5349-1.
86037780 EXTRACTOR 05/09/08
OPERATION
2
.
3-3