Table of Contents
Advertisement
1 . Keep tops of batteries clean and dry.
Use a damp cloth with a weak SOlutlOn
of baking soda or ammonia and water.
Use a clean dry cloth to wipe battery
tops dry after cleaning.
2 . If corrosion (white deposits) appears on
the battery terminals and cable clamps,
remove and clean. Use a battery terminal
and connector cleaning tool.
N AL CLEAN E R
BATTERY TERM
I
3.
Keep the battery electrolyte at the
-
correct level
approximately 114" below
bottom of filler tube of each cell. Dis-
tilled water should be added, as needed,
AFTER charging cycle.
WARNING:
Do not allow electrolyte
SCRUBBER
Before making any adjust-
ments or repairs to the machine..
1 . Only qualified maintenance personnel
are to perform repairs.
2 . Make sure battery charger is dlscon-
3.
Make sure all switches are "OFF"
4 . Remove batteries as required or dlscon-
nect main battery leads from batteries
when making repairs to electrical system.
VACUUM MOTOR
1. Disconnect motor leads from connector
and lift out vac motor.
2. Check motor brushes
DRIVE CHAIN
1. Remove left side skirt and side panel.
2. To remove chain, remove retaining clip
and pull out master link.
3.
To adjust chain tension
A. Remove traverse drive pulley.
.
B .
Loosen lock nut and back out screw
C. Use a hammer and punch to rotate
the eccentric bushing to tighten or
loosen the drive chain.
QEAR UNIT
1 . Loosen belt tension screw and remove
belts.
-
when worn to
2. Remove pulley to allow removal of left
hand lift arm.
3.
Remove right hand pivot bolt, bushing
and lift arm.
. . .
4. To check gear unit oil level
Inspection plug; oil should be at the
bottom of hole. To add 011, remove fill
plug and add 90 welght oil as needed.
TRAVERSE DRIVE MOTOR
1 . Remove lower right hand side skirt.
2. Disconnect motor leads from terminal
3.
Remove snap ring from end of motor
pivot shaft.
-
remove
5
Advertisement
Table of Contents
