Installing Memory; Figure 26. Installing Memory - Intel SE7501BR2 - Server Board Motherboard Product Manual

9. Re-insert the heat sink over the top of the processor.
10. Install new retention clips. Use the retention clips that shipped with the new processor or use a
new set. Retention clips may differ from one processor to processor and should not be reused.
See Figure 14.
NOTE
When the SC5200 Hot Swap Redundant Chassis is used, disregard steps 11 and 12.
11. For chassis that require the PWT assembly, reattach the fan assembly to the retention
mechanism. Pull the tabs at the sides of the retention mechanism apart slightly.
See Figure 17, 1. Lower the fan assembly into the retention mechanism. The tabs on the fan
assembly (Figure 17, 3) will fit into the slots of the retention mechanism (Figure 17, 1). Pull
out on the tabs located at the bottom of the fan assembly to snap them into place on the
retention mechanism.
12. For chassis that require the PWT assembly, reattach the CPU fan.

Installing Memory

The server board supports only DDR266 compliant DIMMs. The minimum supported memory
configuration is 256 MB, using two 128 MB DIMMs. The maximum configurable memory size is
8 GB using four 2 GB DIMMs.
DIMMs must be installed in pairs and must be populated per bank starting with DIMM 1A and 1B
(contiguous sockets). Although the SE7501BR2 server board architecture allows the user to mix
various sizes of DIMMs between banks, DIMMs must be identical within the banks. For a list of
tested memory, see:
http://support.intel.com/support/motherboards/server/SE7501BR2
52

Figure 26. Installing Memory

Intel Server Board SE7501BR2 Product Guide
DIMM 1A
DIMM 1B
DIMM 2A
DIMM 2B
OM14665