Recording - Panasonic HDC-SD800P Owner's Manual

The u nit isput i nto recording pause approx. 1second when t he unit isturned on with the
mode set t o_ or O.
• Depending on the recording conditions, start time may be longer than 1 second.
• In the Quick power on mode, the zoom magnification becomes 1 ×.
This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened.
• When in Quick start standby mode about 80% of the power used in Recording pause
mode is being consumed, so the recording time will be reduced,
• Quick start will not work if there is no SD card inserted.
• Change the mode to _ or O.
1 Set [QUICK START] to [ON].
2 Close the LCD monitor while the mode is set to
mlR or _.
The status indicator O flashes green and the unit goes into
Quick start standby mode.
• The lens cover does not close.
3 Open the LCD monitor.
The status indicator O lights red and the unit is put into
recording pause.
• Quick Start Standby Mode is canceled if
about 5 minutes have elapsed
mode is set to []
• Depending on the recording conditions and menu settings, time for Quick start may be
longer than 0.6 seconds.
• It may take some time for Automatic white balance to adjust.
• In the Quick Start Mode, the zoom magnification becomes 1 ×.
• If [ECONOMY] (-) 42) is set to [5 MINUTES] and the unit automatically goes into Quick
Start Standby Mode, close the LCD monitor and then open it again.
• Turn the unit off using the power button.
• Quick start standby mode cannot be released by the remote control.
Please refer to page 47.
43
VQT3K35